I just used ordinary electrical solder. It works pretty well. the key is to get a blob of solder to sit into the hole and fill it, then sand off the top and bottom, which pushes the soft alloy into the gaps making a pretty good seal, such that it doesn’t drop out. It’s. really cheap, easy, fast way to fill a metal hole.looks good,what method did you use to fill the holes?
She has been transformed...amazing work!!View attachment 140088
Nice new earth lining board
View attachment 140089
Nice new earth braid
View attachment 140090
Insert reinstalled
View attachment 140091
Coin door back on. Earth bonding straps all reinstalled. I’ve tested for earth continuity to the legs, side rails, power switch plate, lockdown bar, etc. All good so far.
Wish I was brave enough to do something like this.
And had the machine to do it with
And a garage or something to do it in
And the skills to actually do it.
Hmmm. Not sure about that either. That's easier to find somewhere if the other prerequisites are met however.Sounds like you've already got the most elusive thing though - the time do it!!![]()