So I lifted the Ant-Man guide to try and stop the pooling and avoid chipping, glad I did as it was probably going to get worse and currently it’s very minimal.
Placed the smallest washer I could find under the rail leg, sorry should have paid attention to what washer I used but basically the smallest that would fit on the rails leg, had to screw it on the leg by hand as the thread was tight.
Put everything back on (ramp after ramp after ramp lol) and then gently tightened the rail until it gripped the washer just enough and the guide wasn’t moving.
Chucked about 30 games on it since and it seems to be working perfectly, no interference with the ball and the rail is nicely off the playfield now, fingers crossed it’s done the job. Thought I would post this up Incase it comes in handy for anyone else.
View attachment 124835View attachment 124836View attachment 124837View attachment 124838