Hey guys
Picked up a pinbot on Sunday. I knew the drop targets weren’t resetting and to be fair I can’t turn the machine on at the moment as I’m waiting on new power cord so I haven’t actually tried it.
However, I noticed these two wires tied up in the loom next to the drop targets.
Grey/Yellow and black/yellow
I think it stems from Connector 1J11
If anyone has a pinbot I’d really appreciate a pic of where they go.
I’ve had a quick glimpse of the manual but couldn’t fathom where they went.
Any advice appreciated.
Oh and any pics of the wiring from the power supply
I currently have this configuration
As always, thanks in advance
Gaz
Picked up a pinbot on Sunday. I knew the drop targets weren’t resetting and to be fair I can’t turn the machine on at the moment as I’m waiting on new power cord so I haven’t actually tried it.
However, I noticed these two wires tied up in the loom next to the drop targets.
Grey/Yellow and black/yellow
I think it stems from Connector 1J11
If anyone has a pinbot I’d really appreciate a pic of where they go.
I’ve had a quick glimpse of the manual but couldn’t fathom where they went.
Any advice appreciated.
Oh and any pics of the wiring from the power supply
I currently have this configuration
As always, thanks in advance
Gaz