*Updating to save people reading through*
Machine boots normally. On game start, no ball is released and the plunger idly fires periodically.
Checked continuity and power (results below). Can ground all coils at the connectors and fire each successfully on J2 and J8.
On coil test, nothing on the violet ribbon is working (VUK, Release, Launch, Eject etc). Everything else working fine.
Quick question, board has a 12 pin connector but annotated them on the board 1-10 (ignoring 2 absent pins).
Manual states a wire is at 7. As per the molex it’s number 7, as per the annotation on the board it’s 6.
Which is correct?
Sent from my iPhone using Tapatalk
Machine boots normally. On game start, no ball is released and the plunger idly fires periodically.
Checked continuity and power (results below). Can ground all coils at the connectors and fire each successfully on J2 and J8.
On coil test, nothing on the violet ribbon is working (VUK, Release, Launch, Eject etc). Everything else working fine.
Quick question, board has a 12 pin connector but annotated them on the board 1-10 (ignoring 2 absent pins).
Manual states a wire is at 7. As per the molex it’s number 7, as per the annotation on the board it’s 6.
Which is correct?
Sent from my iPhone using Tapatalk
Last edited: