Wheel of Fortune up post

[Orgyofclowns]

Hi everyone

My Table has formed an issue on the left ramp up-post there the ball is getting stuck then popping past the post on a ball recovery mode. The post seems a bit too high. Is there anyway to adjust these to lower it a bit and if so how do you know the correct position? I've included the part diagram. Guessing it's between 1 and 7

Would much appreciate any help

Cheers
Rhys

 

[Moonraker]

It looks like Part 7 is an adjustable screw to determine the height of the drop target when it is down. If the target is sitting too high you'll need to take a few turns out of it until the height is correct.

 

[Orgyofclowns]

Yeah that fixed it easy enough. Did it halfway and works perfect now. The KEP nut has gone so need to replace that. Have used a bit of sticky paper for now