Heh... Good luck tomorrow Luke. 
Pinball info
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Pinball head stuck on :(
- Thread starter lukewells
- Start date
How far on the bolts are the t nuts? I've got some long special keys that upse at work just thinking will it slip over the t nut to hold it then un bolt!
OP
OP
There is only about 1mm up/down play in the bolt, so almost fully on.
Are these like sockets for T-nuts?
No but was thinking that the bolt may go inside the key then the hex of inner part of key would hold nut
I'm going to try attacking it tomorrow night with a drill, and if that doesnt work then well, it's buggered.
I'm fairly sure that it will not be possible to jam up the T-nuts, they've just torn through the original wood, they are really stuck on the bolts
Calls for a brand new drill bit - give it the best chance of success
OP
OP
Drilled out the bolts last night. Took a hell of a lot of drilling and the bottom of the cab is now full of metal spirals as we couldn't work out how to use Tonys hoover 
Used an expensive Dormer titanium nitride tipped drill bit. It's certainly not as sharp as it was when I started drilling the first bolt
Used an expensive Dormer titanium nitride tipped drill bit. It's certainly not as sharp as it was when I started drilling the first bolt
Well done Luke.
I knew you would use the force Luke 
OP
OP
haha thanks guys
