So here's a log of the work I completed on the weekend on my newly acquired Jurassic Park LE.
Wife wanted orange so went with a full kit of Titan replacement rubbers.
@Ads Nems Never unfortunately go around to installing his Shooter rod or hooking into the power to the topper. These are truly amazing pieces of kit. I wasn't going to keep the Tilt topper but after watching it light up I seriously cannot be bothered with the official release.
Video of the Amber Rod and Topper installed and powered.
Amber Rod install:
Rubber Kit next:
Cleaned off the flippers:
Slingshot removal:
Also had some @Colywobbles protectors in the coin box so installed those too:
Did the channels at the same time below the slings:
Had to do some plastic adjustment as the ball was catching...
This area was a bit of a pain...
Raptor area was also a PITA required a lot of removal to get the rubbers and posts in this area.
Posts in these area's were simple enough.
The posts for a the T-REX area were a bit of a faff had to move plastic air ball protector, 'cliffy' protector and move the ramp above...
Also installed the pterodactyl mod while i was at it.
The rubbers near the pop bumper area's were also a sod I had to do a lot of juggling with plastics, metal posts and ramp adjustments to get all the rubbers off. Had my wife going 'just leave it'. I honestly couldn't I wanted the whole lot as one theme....
End result:
Check list:
PSU Fan replacement (fans have been ordered)
Install some simple signs near the T-REX fence.
Wife wanted orange so went with a full kit of Titan replacement rubbers.
@Ads Nems Never unfortunately go around to installing his Shooter rod or hooking into the power to the topper. These are truly amazing pieces of kit. I wasn't going to keep the Tilt topper but after watching it light up I seriously cannot be bothered with the official release.
Video of the Amber Rod and Topper installed and powered.
Amber Rod install:
Rubber Kit next:
Cleaned off the flippers:
Slingshot removal:
Also had some @Colywobbles protectors in the coin box so installed those too:
Did the channels at the same time below the slings:
Had to do some plastic adjustment as the ball was catching...
This area was a bit of a pain...
Raptor area was also a PITA required a lot of removal to get the rubbers and posts in this area.
Posts in these area's were simple enough.
The posts for a the T-REX area were a bit of a faff had to move plastic air ball protector, 'cliffy' protector and move the ramp above...
Also installed the pterodactyl mod while i was at it.
The rubbers near the pop bumper area's were also a sod I had to do a lot of juggling with plastics, metal posts and ramp adjustments to get all the rubbers off. Had my wife going 'just leave it'. I honestly couldn't I wanted the whole lot as one theme....
End result:
Check list:
PSU Fan replacement (fans have been ordered)
Install some simple signs near the T-REX fence.
