Thanks both for the help.
Set up pricing as per the link supplied by
@Paul
Messing about with the jumpers as supplied by
@Jay Walker
J1 and J2 on all coins register on switch D2 - Centre coin slot (50p)
J1 and J5 on 10p registers on switch D4 - 4th coin slot (10p)
J1 and J7 on 50p registers on switch D2 - Centre coin slot (50p)
For info my homemade connecting wire is made up like this (and tested OK)
Thanks both for the help.
Set up pricing as per the link supplied by
@Paul
Messing about with the jumpers as supplied by
@Jay Walker
J1 and J2 on all coins register on switch D2 - Centre coin slot (50p)
J1 and J5 on 10p registers on switch D4 - 4th coin slot (10p)
J1 and J7 on 50p registers on switch D2 - Centre coin slot (50p)
For info my homemade connecting wire is made up like this (and tested OK)
C220 | C220 | Pinball | Pinball |
| Pin | Pin | |
Comm.A | 1 | 3 | COMA |
Acc.1 | 2 | 15 | COIN1 |
N/C | 3 | 2 | N/C |
Acc.2 | 4 | 14 | COIN2 |
Acc.3 | 5 | 13 | COIN3 |
Select | 6 | 12 | SEL. |
Acc.4 | 7 | 5 | COIN4 |
Inh.4 | 8 | 9 | ENABLE COINS 4 |
12v | 9 | 4 | +12VDC |
0v | 10 | 1 | PWR.GND |
Inh.3 | 11 | 8 | ENABLE COINS 3 |
Inh.2 | 12 | 7 | ENABLE COINS 2 |
Inh.1 | 13 | 6 | ENABLE COINS 1 |
Inh.5/6 | 14 | 10 | ENABLE COINS 5/6 |
Inh.5/7 | 15 | 11 | ENABLE COINS 7/8 |
I have 2 C220s (Seller on e-bay messed up my address, but that's another story) and the 2nd one is exactly the same, I'm guessing the seller had not programmed them the way they say they have
1 - £1
2 - 50p
3 - 20p
4 - 10p
6 - £2
Does anyone know how to set the unit value for slots 5 through 8 in the T2s menu, it only seems to have settings for Left, Centre, Right and 4th
@Paul In some past posts you have been reprograming these C220s or selling correctly programmed mechs is this something you are still doing?