Ghostbusters Pro - 6k (or 6.5k with LCD Colour DMD)
Bought this a couple of months back for 6k, since then I’ve done the following:
Re-tapped & fitted bigger grub screw to Slimers shaft (
) as this had worn away and was slipping leading to the game not realising Slimer was in the down position & therefore not registering hits - all working perfectly now.
Crimped a metal sleeve round Slimer cable (known fix from Pinside to improve Slimer hit recognition consistency)
Re punched rivets & fitted small brace to right ramp diverter. Rivets had come loose enough for diverter to jam open. This works perfectly now.
Minor marks on rails touched up & rubber grommets on back box replaced.
Two broken EOS switch’s fixed (one leaf switch & one EOS actuator replaced)
Backbox decals replaced (both sides)
Official Art Blades added.
Under cab lighting added (you’ve been slimed!)
Cols protectors (x3) and door plaque added.
Blue rubbers replaced. All playfield rubbers replaced (wasn’t necessary but I changed these back to black from white)
Playfield is in great condition, just minor wear to right saucer & be aware the left scoop normally has a metal protector round it, this was broken so has been removed.
Cabinet & backbox art also in great condition.
I’m asking for exactly what I paid (6k) or 6.5k with LCD Colour DMD fitted.
* There is one outstanding issue where by any time the Slimer motor is in use, some of the lower playfield inserts flicker. Slimer is only used to start a mode, during multi ball & to finish one of the 9 modes also so it’s not something you see too often to be fair. See video link below. *
Overview video:
Lights flicker:
Happy to answer any questions, send more pics, chat on the phone or host a pin session

Bought this a couple of months back for 6k, since then I’ve done the following:
Re-tapped & fitted bigger grub screw to Slimers shaft (

Crimped a metal sleeve round Slimer cable (known fix from Pinside to improve Slimer hit recognition consistency)
Re punched rivets & fitted small brace to right ramp diverter. Rivets had come loose enough for diverter to jam open. This works perfectly now.
Minor marks on rails touched up & rubber grommets on back box replaced.
Two broken EOS switch’s fixed (one leaf switch & one EOS actuator replaced)
Backbox decals replaced (both sides)
Official Art Blades added.
Under cab lighting added (you’ve been slimed!)
Cols protectors (x3) and door plaque added.
Blue rubbers replaced. All playfield rubbers replaced (wasn’t necessary but I changed these back to black from white)
Playfield is in great condition, just minor wear to right saucer & be aware the left scoop normally has a metal protector round it, this was broken so has been removed.
Cabinet & backbox art also in great condition.
I’m asking for exactly what I paid (6k) or 6.5k with LCD Colour DMD fitted.
* There is one outstanding issue where by any time the Slimer motor is in use, some of the lower playfield inserts flicker. Slimer is only used to start a mode, during multi ball & to finish one of the 9 modes also so it’s not something you see too often to be fair. See video link below. *
Overview video:
Lights flicker:
Happy to answer any questions, send more pics, chat on the phone or host a pin session


Last edited: