What's new
By:
Pinball info

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Frying pan, fire. Stern Turtles, lower left flipper not working. Any ideas?

johnh

johnh

Site Supporter
10 Years
Joined
Apr 17, 2012
Messages
273
Location
Bournemouth
It's one of life's mysteries. You buy a machine that has never had a problem in its short life, put it in a van for a few hours, then it all goes pear shaped. But, it's giving me an opportunity to learn about Spike 2 :) Machine was playing fine, then wouldn't boot. Reseated the SD card, this all sorted. Upgraded to the latest s/w, all good for a couple of games. then it developed an intermittent (1 in every 5 actuations) delay on the flippers, and when the left flipper was held up , the right flipper would drop (not vice versa though). Reseated all the connectors on Node Board 8. Now, the issue has morphed and the lower left flipper not working at all now in game (right flipper, upper left flipper working fine). All flippers working fine in coil test, both flipper buttons working fine in switch test.
So, I've run out of logic. If the coils test works, then it might indicate a switch issue. But if the switch tests work, doesn't that rule out a switch issue?
Collective wisdom of this group gratefully received.

John
 
This place has far more wisdom :).
Update from Johns text based live stream….1) the left flipper button isn’t working in switch test. I forgot that it’s two stages, so only the upper flipper switch is registering
2) if put some pressure on the connector on the node board, it’s back working again, so it’s definitely the connector on the node board, or perhaps a cold joint on the board itself.
 
It’s going to be the pins, they are **** poor

M

Thread 'Stern spike 2 switch problem'

I am as new to this as can be, so any help or advice would be gratefully appreciated.

The lil Deadpool bash toy isn’t registering hits, from what I can see, the leaf switch making contact when pressed, but the switch test always has an “x” I tried bridging the pins on the black/red + white/brown wire, but no change.

Traced it back to the CN12 connector and it looks well seated.

Any idea what to try next?
 
I’ve ordered 100 😆 if you pop the pin out, I’m sure the end will have snapped off.

Across my machines, there are at least a dozen needing replaced
 
You can get it working again (until you replace it) by bending the end down a bit to make a hook.

They’re the worst pins I’ve ever came across 🙄

Mine are coming from America with a load of other stuff, so it’ll be another week at least, but I can send you some when they arrive
 
Well that's bloody annoying! If it had done that before you took it away I could have fixed it easily as I've got loads of those pins here :mad: @johnh I can bring some to Pinfest on Sunday for you if you like mate? I'm assuming it's the 0.100" ones?
 
You must log in or register to reply here.
Back
Top Bottom