Whilst going over my Creature from the Black Lagoon pinball I noticed that the start button is not lit up (it's on free play).
I'm pretty sure I'm getting pulsing voltage from the bulb holder, but just to be sure I replaced the who assembly including new button and bulb.
I've measured D1 on the coin door interface board and getting the following reading, does this look in spec? I'm getting 0.L the other way.
Continuity from the lamp pin to the diode and then to the second pin on the right is good.
I'm pretty sure I'm getting pulsing voltage from the bulb holder, but just to be sure I replaced the who assembly including new button and bulb.
I've measured D1 on the coin door interface board and getting the following reading, does this look in spec? I'm getting 0.L the other way.
Continuity from the lamp pin to the diode and then to the second pin on the right is good.
Attachments
Last edited: