R
robertlucas1970
Should these be active and working or are they for things like tournament mode ?
I have one coil that I have not seen work, so ran the test and it does nothing when I run it, AUX 2
Its on T3 the center up post between the flippers, so lifted the table up and wire has been cut next to the coil and a little protector put over it, so for some reason it has been disconnected, so have reconnected it and had a look in the book.
I know a little bit but not a lot so please go easy on me.
This coil is on J7 P9 VIO/Black, but this is where I get a little confused as on the coil is red and this red wire then goes to a 3 way driver board, but I do not see the VIO/Black from the main driver board on this 3 way driver board, the inputs are orange with stripes.
Before I go any further I just wanted to make sure this coil should be working and not some feature of the machine that could be used in tournament mode or something else.
Any tips please fire this way.
Many Thanks
Robert
I have one coil that I have not seen work, so ran the test and it does nothing when I run it, AUX 2
Its on T3 the center up post between the flippers, so lifted the table up and wire has been cut next to the coil and a little protector put over it, so for some reason it has been disconnected, so have reconnected it and had a look in the book.
I know a little bit but not a lot so please go easy on me.
This coil is on J7 P9 VIO/Black, but this is where I get a little confused as on the coil is red and this red wire then goes to a 3 way driver board, but I do not see the VIO/Black from the main driver board on this 3 way driver board, the inputs are orange with stripes.
Before I go any further I just wanted to make sure this coil should be working and not some feature of the machine that could be used in tournament mode or something else.
Any tips please fire this way.
Many Thanks
Robert