Hello
I have started to think that fixing pins is more rewarding that playing them. I must be getting mad.
So last week i fixed a flipper that kept on flipping frantically by replacing the coil (advice from this very forum). That was my first coil replacement and it went swimmingly ok. Probably helped by the fact that at last I have understood how I am meant to solder.
Anyway that's not the purpose of this thread, my next (and last at the moment) problem is the displays on my vector. None of them are on. I know they are ok because I had them tested and they were working fine. And also occasionally numbers appear on some of them. Otherwise all displays on the back box are blank. It looks like a central problem as opposed to a problem at each display. But the question is: where do I start? I don't even know which board in the back box drives the displays... Any help welcome. Keep it simple. Learner here.
Thank you
Dom
I have started to think that fixing pins is more rewarding that playing them. I must be getting mad.
So last week i fixed a flipper that kept on flipping frantically by replacing the coil (advice from this very forum). That was my first coil replacement and it went swimmingly ok. Probably helped by the fact that at last I have understood how I am meant to solder.
Anyway that's not the purpose of this thread, my next (and last at the moment) problem is the displays on my vector. None of them are on. I know they are ok because I had them tested and they were working fine. And also occasionally numbers appear on some of them. Otherwise all displays on the back box are blank. It looks like a central problem as opposed to a problem at each display. But the question is: where do I start? I don't even know which board in the back box drives the displays... Any help welcome. Keep it simple. Learner here.
Thank you
Dom