hi all.can anybody give me a clue on how i take off the gumball from my tz as i have to change the geneva switch and there is no room to put nuts on rhe switch with gumball in place,thanks dean.
Is the switch def not working ? I only ask as it’s not uncommon on TZ to get the Geneva Switch error come up when in fact it’s fine . I can’t remember the exact reason for this .
Anyway removing gumball machine guide , lifted from Pinwiki ……
Remove GumBall Machine -
This is described on page 1-54 of the manual, but it is not so easy to do, so here's revised instructions courtesy the clever folks on RGP.
Lift playfield and remove rear wood panel from machine - 5 wood screws.
Note, on my machine I had to move the divertor that sends balls to the gumball VUK so I could access the middle screw.
When all 5 screws are removed, the panel will fall into the machine, so, if you don't want it to fall, hold on to it.
Remove plastic (xxx-6-sp) on right side of gumball.
Remove 3 level plastic on left side of gumball. Since the back is no longer in the way, twist it up and back to remove.
Remove 2 hex head wood screws from the VUK wireform.
Remove 3 hex head wood screws from the gumball machine.
Remove the VUK wireform from the gumball machine - pull up and back.
Remove gumball machine - twist sideways and lift up at rear.
Attach wireform to gumball machine when replacing it.