Cant recall if I asked this before - but if I did I cant find the thread.
Looking for someone that is able to take my CG System 7 MPU/Driver board give them a once over with a view to repair. CG has a rotten dog in it currently - currently trying to track down an issue with the switch matrix which im cautiously optimistic I can fix. It *did* have an intermittent fault with double flipper reset.. which I seemed to have fixed.. until it wasnt.. then seemed to be OK.. until it wasnt again.
I have the original boards from it so thinking might be worth getting those repaired - even if I fix the issues a spare set of Sys 7 boards wont go amiss. Depending on cost of course (but then the only Sys 7 replacement I can find is $499 from http://pinballpcb.com/ plus shipping and customs I expect.
Looking for someone that is able to take my CG System 7 MPU/Driver board give them a once over with a view to repair. CG has a rotten dog in it currently - currently trying to track down an issue with the switch matrix which im cautiously optimistic I can fix. It *did* have an intermittent fault with double flipper reset.. which I seemed to have fixed.. until it wasnt.. then seemed to be OK.. until it wasnt again.
I have the original boards from it so thinking might be worth getting those repaired - even if I fix the issues a spare set of Sys 7 boards wont go amiss. Depending on cost of course (but then the only Sys 7 replacement I can find is $499 from http://pinballpcb.com/ plus shipping and customs I expect.