View attachment 59594 Another pile of **** buy from pinball centre Newton ball I could have welded a ball to a bolt myself straight in the bin me thinks
I always like to change flipper buttons when I get a new (to me) machine. Nothing worse than the thought of it coming from some pub where people nip for a slash in between gamesAll done with some new flipper buttons fit too
The side rails had massive dents in due to the back box dropping on them I have lots of these in good nick left over from full restoration jobs so a better set fit if anybody can recommend a better way to remove the old tape other than the hair dryer I am all ears
19mm expensive stuff at £100 for 30 metres but once it on it’s not coming off cheep stuff always pops off after a bitLooks great @chris b , The 3M VHB tape - 10, 12 or 19mm?
Cheers
I don’t think there is any easy way to remove it unless you buy newI was told that a hair dryer wasn't hot enough and it had to be a heat gun. I don't have a working heat gun so I sprayed on WD40 and did a lot of tedious scraping.
19mm expensive stuff at £100 for 30 metres but once it on it’s not coming off cheep stuff always pops off after a bit
Cheers 5952F by any chance? Obviously not doing as many resto's as you and at that price need to get shorter length19mm expensive stuff at £100 for 30 metres but once it on it’s not coming off cheep stuff always pops off after a bit