Wiring question...

[Beeper]

OK, I was planning on mounting two spot lights on a spacer post above sling shot then dropping down through sling into the GI for power. Ideally rather than running 4 wires (2 x 2) below to connect to the GI I will attach them both to each other so just two wires run down the spacer and below the pf.

My question is, as per the pic below, is there any specific/better way to wire the 555 holders together? I.e. A to GI, D to A, B to C and C to GI? Also, is there an easy way I am missing to remove the wires from the holders to do a neater job then splicing the wires together? Pic below of the holders too.

This is all probably very straight forward...

Thanks

 

[Julian]

A to GI, B to C and then D to other side GI should do the trick.

 

[Beeper]

Cheers mate - think I was over thinking this!

 

[aaronhicksuk]

GI lights are normally wired in parallel. I'd connect A and B to either side of the GI and then A to C and B to D. Julians method will work but the lights probably wont be that bright in series.

 

[Beeper]

GI lights are normally wired in parallel. I'd connect A and B to either side of the GI and then A to C and B to D. Julians method will work but the lights probably wont be that bright in series.

Yeh - this is where I was originally going with this... any idea how/if the wires can be removed from the holder? If possible I could do something neater joining the wires... or suggestions on how best to solder these together?

Cheers for the help

 

[Beeper]

Cheers for the help chaps. Had a play around tonight and happy with the result: