Drew.m Site Supporter Joined Jul 18, 2016 Messages 481 Location Bradford/York Alias Drew Oct 12, 2018 #1 Hi chaps, could someone measure the height of the holes in the cabinet for the legs please?
OP OP Drew.m Site Supporter Joined Jul 18, 2016 Messages 481 Location Bradford/York Alias Drew Oct 13, 2018 #2 Can anybody help with the leg bolt positions on a wh20 as I have measured my other machines and they are all different
Can anybody help with the leg bolt positions on a wh20 as I have measured my other machines and they are all different
replicas Site Supporter Joined Jul 21, 2011 Messages 12,046 Location Lancashire Alias Nipper Pinball Oct 13, 2018 #3 Is your doner cab a Addams ?
replicas Site Supporter Joined Jul 21, 2011 Messages 12,046 Location Lancashire Alias Nipper Pinball Oct 13, 2018 #4 If so both front and rear are identical.
replicas Site Supporter Joined Jul 21, 2011 Messages 12,046 Location Lancashire Alias Nipper Pinball Oct 13, 2018 #5 Front from base to centre bottom hole 104mm. Rear from base to centre bottom hole 55mm. Hope that helps.
Front from base to centre bottom hole 104mm. Rear from base to centre bottom hole 55mm. Hope that helps.
OP OP Drew.m Site Supporter Joined Jul 18, 2016 Messages 481 Location Bradford/York Alias Drew Oct 13, 2018 #6 Thanks that really helps, yes the donor is an Addams
OP OP Drew.m Site Supporter Joined Jul 18, 2016 Messages 481 Location Bradford/York Alias Drew Oct 13, 2018 #7
OP OP Drew.m Site Supporter Joined Jul 18, 2016 Messages 481 Location Bradford/York Alias Drew Oct 13, 2018 #8 That will explain why the old cabinets playfueld was too shallow