Whirlwind.
So I installed a new upper flipper coil. crossed two wires from the eos and blew a trace. So the right flipper moved in slow motion and the two right flippers did not move.
I repaired the trace. corrected the wiring.
started the pin and blew F5 fuse. Flipper.
Replaced that, and thought the upper coil that I replaced may be the issue now.
So I disconnected it but kept the power to the lower flipper.
Started the machine again.
Now both lower flippers move in slow motion when the buttons are pressed?
They are not hot, the sleeves are not melted, the pawls move in and out smoothly. (on all 3 actually)
Any ideas.
Is it possible its just the diodes on the coils?
So I installed a new upper flipper coil. crossed two wires from the eos and blew a trace. So the right flipper moved in slow motion and the two right flippers did not move.
I repaired the trace. corrected the wiring.
started the pin and blew F5 fuse. Flipper.
Replaced that, and thought the upper coil that I replaced may be the issue now.
So I disconnected it but kept the power to the lower flipper.
Started the machine again.
Now both lower flippers move in slow motion when the buttons are pressed?
They are not hot, the sleeves are not melted, the pawls move in and out smoothly. (on all 3 actually)
Any ideas.
Is it possible its just the diodes on the coils?
