First thing is to find out what works and what requires attention, powered up and found the following: Service Switched dodgy, Pop bumper not popping, lights out on playfield lots of dead rafts, ball sticks on ramps, hot foot bigfoot lower switch dead, quite a few dead switches in a couple of optos on the VUK, No sound, shallow pitch on playfield. I must add at this juncture the seller made me aware of these issues at time of sale so non of this is meant as a moan. Nice pic of playfield all it needed cosmetically was a dust
Time to start the move to the new cab now i am aware of the issues that need addressing and if anything else crops up it was my fault when moving the playfield. First thing is to install the skids and move the playfield supports
A couple of mm high but i am sure its ok, test fit the playfied and bugger! the plunger hole is too high so will need to move the hole. Filled and sanded
Better pic with the skids installed, i used screws rather than glue just in case i made a balls of it
Moved the plunger hole (router) fit playfield and test height
Quite pleased with that, ( the eagle eyed amongst you will be able to tell i took this picture a bit further on in the process as i forgot to take it during

next up give the cab a spray and rub down
I know it looks like i have bitten out the plunger hole but i did tidy it up after this pic was taken, next strip all bits out of old cab and clean up, i decided to spray the power bits blue to go with the theme
after
Also re-built test switch with supplied new switches and printed new instruction sheet (spot the mistake!!!)
Stuck the Side blades on with the help of a bit of spray mount and fit the cabinet components and earth braid.
