Hello guys
I have a pinbot sys 11 and the mpu does not want to boot.
I have 5v and 13.6v on the power driver test points but when I hook up the mpu the 13.6v dropp 10.6v
Does this mpu need a proper 12v to boot?
Resistor 56 has 12ohms insted of 10ohms should i replace this resistor?
I have a pinbot sys 11 and the mpu does not want to boot.
I have 5v and 13.6v on the power driver test points but when I hook up the mpu the 13.6v dropp 10.6v
Does this mpu need a proper 12v to boot?
Resistor 56 has 12ohms insted of 10ohms should i replace this resistor?