Tz reset issues on two flipper use

[Gregors]

Reseated all connections to power board
Cleaned connections on powerboard too with emery
This initially fixed the problem but now back!
Any further ideas??




Sent from my iPhone using Tapatalk - now Free

 

[pinballmania]

Press home square ASIC on CPU might help

I suspect that ultimately you will have to replace the loom connector that attaches to J114 on the power board.

 

[Gregors]

Thanks Andy I'll give it a go
Justin (you put rails on my Addams in hove last year)


Sent from my iPhone using Tapatalk - now Free

 

[pinballmania]

If reseatting the chip doesn't help , reseat j114 again to prove it is the root cause.

 

[Gregors]

Tried the chip no different
Reseated j114 no different
Reseated z-connector on the j114 loom threw up error on r flipper eos and a couple of others(strange)!, and still reset.
Does this mean I should change both connector on j114 and also the z connector?


Sent from my iPhone using Tapatalk - now Free

 

[Gregors]

Swapped power ribbon cable with the one on my taf - no resets!!


Sent from my iPhone using Tapatalk - now Free

 

[pinballmania]

Just for clarity,
The grey ribbon cable
Or
The power wiring including connector J114?

 

[Gregors]

Grey 3.5" ribbon between CPU and power.
I'll drop thru an order for a new one later.
Thanks matey.


Sent from my iPhone using Tapatalk - now Free