So my next project pin is the Bride of PinBot.
I guess I will need a playfield rotisserie, any suggestion on where to get one? I have see they can be built I'd rather not do this if one can be purchased, failing that I will just have to build one.
My question is where does one start? I looked under the playfield and thankfully BoP does not have that much going on 'down-there' does one unscrew everything but leave it in place to finally slide old playfield out and slide new one in then re-fix everything?
It goes without saying I will be taking loads and loads of photos.
Or do you de-solder all components? labeling up every wire.
Is there 2 or 3 wiring looms that are just cable-tied together? i.e. high voltage, GI and controlled bulbs.
Any and all help greatly recieved.
Julian
I guess I will need a playfield rotisserie, any suggestion on where to get one? I have see they can be built I'd rather not do this if one can be purchased, failing that I will just have to build one.
My question is where does one start? I looked under the playfield and thankfully BoP does not have that much going on 'down-there' does one unscrew everything but leave it in place to finally slide old playfield out and slide new one in then re-fix everything?
It goes without saying I will be taking loads and loads of photos.
Or do you de-solder all components? labeling up every wire.
Is there 2 or 3 wiring looms that are just cable-tied together? i.e. high voltage, GI and controlled bulbs.
Any and all help greatly recieved.
Julian