Any Space Station commander be kind enough to take a clear photo of their interconnect board ? - mounted on the left hand side panel of the back box.
Pinball info
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Space Station Backbox Interconnect board photo needed
- Thread starter Sgt GrizZ
- Start date
Mate I did this vid when I set mine on fire. There might be a glimpse of the board you’re after
OP
OP
Brilliant - muchos gracias 
I need to fix mine next week but it’s currently elsewhere . Needed a reminder of connectors . I remember now it’s J1 which looks like it’s been replaced on yours also . Common fail. My GI was super dim last time I saw it and the connector was fried + board hacked . Needs some tlc.
I need to fix mine next week but it’s currently elsewhere . Needed a reminder of connectors . I remember now it’s J1 which looks like it’s been replaced on yours also . Common fail. My GI was super dim last time I saw it and the connector was fried + board hacked . Needs some tlc.
I would suggest you look into the various GI circuits/ interconnect boards/ relay boards below the playfield (for the green GI).
I rebuilt a number of connectors on mine earlier in the year. I reflowed solder and cleaned board pins too.
There are quite a few nasty circuits on a space station that really stress the boards. Some flasher circuits have 4 bulbs for example.
I cleaned/ replaced all relevant connectors/ bulb holders/ connectors. Replaced some caps. Checked voltages. No matter what I did to mine the one and two bulb flasher circuits are fine. The three are slightly dimmer. The fours are much dimmer.
Could you tell me how your backbox flashers look pls. Maybe the 4 bulb circuits are dimmer and there is nowt that can be done - other than replace with leds
I rebuilt a number of connectors on mine earlier in the year. I reflowed solder and cleaned board pins too.
There are quite a few nasty circuits on a space station that really stress the boards. Some flasher circuits have 4 bulbs for example.
I cleaned/ replaced all relevant connectors/ bulb holders/ connectors. Replaced some caps. Checked voltages. No matter what I did to mine the one and two bulb flasher circuits are fine. The three are slightly dimmer. The fours are much dimmer.
Could you tell me how your backbox flashers look pls. Maybe the 4 bulb circuits are dimmer and there is nowt that can be done - other than replace with leds