Last night i had 2x pins powered up; myBK2k and IJ4. i happened to lean over and my forearm touched the side rails on both and i noticed a sharp tingling. Tried touching 1 hand on each and dont notice anything. Tried again with just my forearm touching across both and definitely getting a shock.
i stuck my mutlimeter on both and its showing 110vac between the machines.
Next i measured between a copper pipe for the water supply (will be tied into earth point) and the IJ4 and got nothing, then tried the same with Bk2k to the copper water pipes and was getting 110v, so definitely something going on with that pin and an earth leakage somewhere.
Where should i be looking on the machine? presuming the power cable, and the PSU?
Both machines are plugged into the same 4 gang extension into the same wall socket.
i stuck my mutlimeter on both and its showing 110vac between the machines.
Next i measured between a copper pipe for the water supply (will be tied into earth point) and the IJ4 and got nothing, then tried the same with Bk2k to the copper water pipes and was getting 110v, so definitely something going on with that pin and an earth leakage somewhere.
Where should i be looking on the machine? presuming the power cable, and the PSU?
Both machines are plugged into the same 4 gang extension into the same wall socket.