Rottendog Data East PPB Board F7

[Solar Sailer]

After a break I'm returning to LW to clear the faults after a strip down. I replaced the PPB board as it was hacked.
However F7 has blown and I can't find any info what F7 is on this board.
It's a 3A SB fuse.

TIA

 

[Fantazia2]

Is it not the same as the original game?


Although it says it should be a 0.5A SB Display Reg Input 90 V.A.C.

https://www.arcade-museum.com/manuals-pinball/L/Lethal_Weapon_3_OPS.pdf

Ignore me its the other board isnt it.

 

[Solar Sailer]

A manual!! Great thank you

Is it not the same as the original game?


Although it says it should be a 0.5A SB Display Reg Input 90 V.A.C.

https://www.arcade-museum.com/manuals-pinball/L/Lethal_Weapon_3_OPS.pdf

No. It has 3 extra fuses in to protect the game.

 

[Fantazia2]

Did they supply a schematic for it, they dont seem to show them on their site.

 

[Solar Sailer]

Did they supply a schematic for it, they dont seem to show them on their site.

I bought the board as they photoshopped out the Roytendog info, which says a lot!

 

[Fantazia2]

Just found a thread about a different fuse blowing and it was grounding out against the ground trace under the fuse holder solder pads, might be worth a continuity check with the fuse removed to check its not the same.

https://pinside.com/pinball/forum/topic/rottendog-ppb001-50vdc-shorting-to-ground

 

[pinballtoys]

from 1994 Tommy manual

 

[Fantazia2]

Beat me to it, the GnR uses the later revised PPB as well and that lists the same 3A SB Flipper Power and 32v Coils Left.