Cheers guys. Here’s the plan, would like your feedback.
I’ve ordered new LED bulbs for the back board after receiving some advice, I understand this should reduce the current draw by some margin? Any idea how much?
I’ll pull the PCB off the machine, desolder and remove the damaged header and solder in a new one.
I’ll check the new connector to see if actually damaged or just a bit of scorching, and replace as reqd.
Hopefully ?it’ll work reliably.
I’ve ordered new LED bulbs for the back board after receiving some advice, I understand this should reduce the current draw by some margin? Any idea how much?
I’ll pull the PCB off the machine, desolder and remove the damaged header and solder in a new one.
I’ll check the new connector to see if actually damaged or just a bit of scorching, and replace as reqd.
Hopefully ?it’ll work reliably.