Looking for £3700
So I wasn't planning on parting with this but a pin I want has appeared and I'll need the funds.
You can view the shop log for it's background.
The game required a lot of work to restore including.
New parts:
Full cabinet and backbox repair
Cabinet and backbox decals
Side rails
Coin door
Replated Chrome ramps
Backbox glass receiver
Sheet of glass
Leg plates
Leg levelers
Flipper buttons
Replacement plastics (select replacements for broken or missing ones)
Titan orange rubbers
LEDs, GI and Inserts
Carriage Bolts
Balls
Apron decals
Shooter plate plastics
Start button
Extra ball button
Ants custom shooter rods
Beer seal for lock bar
Replaced some switches
Face internal parts for Red and Ted
Apron Cards
Fully rebuilt pops including new pop bumper bracket
Other notables:
Repaired and reconditioned Power Driver Board
Fully powder coated: Legs, side rails, shooter plates, lock bar, speaker grills and shooter rods.
Blue painted interior
Elements to note:
Backbox had water damage, as a result of the damage the rear warning text was lost, you can get the silk screen redone if it really bothers you!
Cabinet had warped slightly at the front, this was corrected but has meant the front left is slightly closer than it should be at the joint.
The backbox suffered delamination due the aforementioned water damage, there's a slight lift still on the right side at the bottom. Its not within me to hide anything.
Scoop hole shows ware, easily repaired and covered with a cliffy.
Some posts are tarnished from previous rust, they are cleaned and free of rust now.
DMD has one column on the far right out.
Translite has some scratches but is in overall good condition.
Transformer reconditioned and many parts tumbled and cleaned.
Game was fully stripped with replacement of some coils and new coil sleeves added.
Blast zone post area is worn and needs repair, post removed to prevent further damage.
Game turned out great considering the original condition.
No known faults and plays great!
So I wasn't planning on parting with this but a pin I want has appeared and I'll need the funds.
You can view the shop log for it's background.
The game required a lot of work to restore including.
New parts:
Full cabinet and backbox repair
Cabinet and backbox decals
Side rails
Coin door
Replated Chrome ramps
Backbox glass receiver
Sheet of glass
Leg plates
Leg levelers
Flipper buttons
Replacement plastics (select replacements for broken or missing ones)
Titan orange rubbers
LEDs, GI and Inserts
Carriage Bolts
Balls
Apron decals
Shooter plate plastics
Start button
Extra ball button
Ants custom shooter rods
Beer seal for lock bar
Replaced some switches
Face internal parts for Red and Ted
Apron Cards
Fully rebuilt pops including new pop bumper bracket
Other notables:
Repaired and reconditioned Power Driver Board
Fully powder coated: Legs, side rails, shooter plates, lock bar, speaker grills and shooter rods.
Blue painted interior
Elements to note:
Backbox had water damage, as a result of the damage the rear warning text was lost, you can get the silk screen redone if it really bothers you!
Cabinet had warped slightly at the front, this was corrected but has meant the front left is slightly closer than it should be at the joint.
The backbox suffered delamination due the aforementioned water damage, there's a slight lift still on the right side at the bottom. Its not within me to hide anything.
Scoop hole shows ware, easily repaired and covered with a cliffy.
Some posts are tarnished from previous rust, they are cleaned and free of rust now.
DMD has one column on the far right out.
Translite has some scratches but is in overall good condition.
Transformer reconditioned and many parts tumbled and cleaned.
Game was fully stripped with replacement of some coils and new coil sleeves added.
Blast zone post area is worn and needs repair, post removed to prevent further damage.
Game turned out great considering the original condition.
No known faults and plays great!
Last edited: