Here's a quick extra thing about rfm. I've never noticed this until recently but it seems the auto launcher bracket mounting position is designed pretty badly and seems to give the ball top spin from the shooter lane. Never seemed to be a problem until recently however, but I noticed the ball launch was getting pretty bad recently.
Looking at it in more detail it seems that the bracket just instantly made correctly and the auto launcher in its default position is punching at the top half of the ball.
So, I made a nice quick spacer shim on the 3d printer (6mm thick) and this has sorted it a treat. If you have the same problem and would like one of these to use get in touch
Looking at it in more detail it seems that the bracket just instantly made correctly and the auto launcher in its default position is punching at the top half of the ball.
So, I made a nice quick spacer shim on the 3d printer (6mm thick) and this has sorted it a treat. If you have the same problem and would like one of these to use get in touch
