The auxiliary lamp driver was always a board that i wanted to improve upon. The design was component heavy and needed sorting out.
So here is my version:
I decided to go back to the beginning and redesigned it from the ground up.
Improvements over the original are:
I will be uploading another video later of the board running in my gold wings in place of the old original. On gold wings there are some lamps which strobe all the time in front of the main ramp and this board controls them. It also controls the lamps on the topper if fitted.
They will be available for £40 plus postage assembled.
So here is my version:
I decided to go back to the beginning and redesigned it from the ground up.
Improvements over the original are:
- All new original design, fully compatible with original
- LED power indicator
- Significantly Reduced chip count, 3 instead of 6. (most games will only need 2 ics)
- All socketed ics
- Plate through design
- MOSFET Drivers with 24A rating
I will be uploading another video later of the board running in my gold wings in place of the old original. On gold wings there are some lamps which strobe all the time in front of the main ramp and this board controls them. It also controls the lamps on the topper if fitted.
They will be available for £40 plus postage assembled.
