Hey all,
So thanks a lot again for all the advice for our MM flipper switch over. We got everything working on today and went to play our first game but now the right troll doesn't seem to be popping up.
Both worked previously.
We get a "r. troll up switch is bad" when doing a troll test and it won't pop.
We've had a check over all the cables and they look fine. We tried to use our multimeter but that doesn't seem to be working correctly at the moment. Upon searching for the same error message I found a suggestion of "go into Tests - Switch Edges. Under the playfield you can see the left troll/plunger/coil assembly. There is a micro mini switch the troll carriage closes going up, and opens when going down. Push the switch and see if it's working." We've done that and when trying with both trolls a dot pops up on the display.
Any advice would be appreciated, as I can't find much out there upon searching so we're unsure what to try first (and how to properly detach them/the coil should we need to).
Thanks again
So thanks a lot again for all the advice for our MM flipper switch over. We got everything working on today and went to play our first game but now the right troll doesn't seem to be popping up.
Both worked previously.
We get a "r. troll up switch is bad" when doing a troll test and it won't pop.
We've had a check over all the cables and they look fine. We tried to use our multimeter but that doesn't seem to be working correctly at the moment. Upon searching for the same error message I found a suggestion of "go into Tests - Switch Edges. Under the playfield you can see the left troll/plunger/coil assembly. There is a micro mini switch the troll carriage closes going up, and opens when going down. Push the switch and see if it's working." We've done that and when trying with both trolls a dot pops up on the display.
Any advice would be appreciated, as I can't find much out there upon searching so we're unsure what to try first (and how to properly detach them/the coil should we need to).
Thanks again