What's new
Pinball info

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Just installed rotten dog dmd but only getting orange dots

The seeker

Registered
5Years
Joined
Oct 13, 2015
Messages
1,638
Location
Northumberland
As title states I have a Jackbot who’s dmd display drive board failed last week- I know this as I took one out of white water and fitted in Jackbot and it worked . So ordered new rotten dog one for Jackbot but but on instal I’m just getting all the dots lit. Anyone know where I went wrong ?
 

Attachments

  • 493D987C-1489-4398-9376-C37A12190FE7.jpeg
    493D987C-1489-4398-9376-C37A12190FE7.jpeg
    80.2 KB · Views: 14
Have you tried the rotten dog in White Water?
Same result in 2 different machines and you’ve found the problem. Ken
 
Not sure, is the ribbon cable (0ne going to display) on the new board in the right way, don't remember it looping over, rather hanging down, i could be wrong. Worth checking ribbons are correctly seated anyhow
 
i put it into ww and same result ... seems to be a bad rotten dog board :( its fresh out of the box but upon deep diving in threads these seem to have issues
 
I had that with a Pinled MPU... It does happen... though you would like to think they were tested somewhere along the line before shipping...

If the fault follows the board.. the then fault is usually the board (Especially when another board tests good - therefore proving other pieces of the jigsaw...)
 
Back
Top Bottom