Jurasic Park fault

[Glenn]

Hi,

We are trying to get our Jurasic park pin running that I swapped for some arcade cabinets but at the minute if you press the any of the flipper buttons it goes into slam tilt and the flippers do not move at all. Thinking it might have a faulty flipper control board.

Any pointers would be great.

Many thanks,

Glenn

 

[Moonraker]

I suspect you're right, either a bridge rectifier (!) or flipper control board.

Try checking out the information given here first then report back
http://www.pinwiki.com/wiki/index.php?title=Data_East/Sega

 

[Spandangler]

Yes I had a Baywatch which was slam tilting and it was the flipper board. Is it an aftermarket one perchance

 

[Glenn]

Hey Moonraker, that is great, thanks alot

 

[Glenn]

I does look like it. Had to change some of tye fuse carriers and they seemed cheap. Are the flipper boards easy to get? I am swapping the two bridge rectifiers first as they seem dodge.

 

[astyy]

Glenn this is a good resource for your machine too;
http://techniek.flipperwinkel.nl/desega/

With a bit of guidance you may be able to fix the flipper board with some care and basic soldering skills but new versions are available.

 

[Glenn]

Brilliant, thanks a lot