Gents,
I’ve got a problem with my upper right flipper.
It works but doesn’t move back to the zero stop (dot)
Upon looking at the underside I can see the mech when operational is sluggish - forgive the tech knowledge here but the picture where my finger is a gap where the mech with the sleeve thingy doesn’t hit the rubber bung thus doesn’t allow the flipper to go back to its resting position.
Is there a fix for this?
It doesn’t feel very snappy - not like the small upper left flipper, the bottom two flippers are a bit less snappy but at least they go back to the little dots ok.
Thanks in advance
![B311E6EA-225E-451E-B0F2-370C3D9B4824.jpeg B311E6EA-225E-451E-B0F2-370C3D9B4824.jpeg](https://www.pinballinfo.com/community/data/attachments/91/91905-880ef1dd244648bf6a207cf264c52235.jpg)
![3FD5B018-9C9F-4112-AE1B-8B3AF947C36E.jpeg 3FD5B018-9C9F-4112-AE1B-8B3AF947C36E.jpeg](https://www.pinballinfo.com/community/data/attachments/91/91906-73e26ff144abc1dc968bff9225e6197a.jpg)
I’ve got a problem with my upper right flipper.
It works but doesn’t move back to the zero stop (dot)
Upon looking at the underside I can see the mech when operational is sluggish - forgive the tech knowledge here but the picture where my finger is a gap where the mech with the sleeve thingy doesn’t hit the rubber bung thus doesn’t allow the flipper to go back to its resting position.
Is there a fix for this?
It doesn’t feel very snappy - not like the small upper left flipper, the bottom two flippers are a bit less snappy but at least they go back to the little dots ok.
Thanks in advance
![B311E6EA-225E-451E-B0F2-370C3D9B4824.jpeg B311E6EA-225E-451E-B0F2-370C3D9B4824.jpeg](https://www.pinballinfo.com/community/data/attachments/91/91905-880ef1dd244648bf6a207cf264c52235.jpg)
![3FD5B018-9C9F-4112-AE1B-8B3AF947C36E.jpeg 3FD5B018-9C9F-4112-AE1B-8B3AF947C36E.jpeg](https://www.pinballinfo.com/community/data/attachments/91/91906-73e26ff144abc1dc968bff9225e6197a.jpg)