Indy J drop target

[PUP]

Hi got a replacement drop target bracket from the pinball center in Germany some while back but on coming to fit it the screws that hold the relay bracket in place wont take to the thread although they are the right ones, they fit in the old bracket fine. Its like the holes in the new bracket havent been threaded properly, is it possoble to re drill them or any other ideas?

 

[CHRIS B PINBALLS]

Get a no 6 or 8 unf tap off eBay and re tap them out
Or if you are not in a rush post to me or drop at ph and I will do it for you next time I am there
It’s probably a metric thread on the new one not imperial

 

[AlanJ]

i’ve noticed some of the new stuff is coming as metric not imperial

i bought a flipper rebuild kit and the grub screw allen key i found to fit was metric whereas originals all imp.

 

[PUP]

Thanks, iv got a tool station round the corner from me so will have a see if they have one otherwise il ebay it. I couldnt get my head round it