Hi chaps
Does anyone know of a good way to adapt a table so the glass can lift out, saving all the extra space needed in front of it? I'm thinking of something like a track/hinge affair along one or both rails.
Has anyone done this? Is there a company doing this as a service? Would it still be structurally sound?
I'm sure I'm not the only one who could fit more pins in with something like that - I could then use a 7' space instead of needing it to be 9' to allow for glass removal. I think I read somewhere that a table was made like that way back, but I'm not looking for a history lesson, just is it a viable upgrade nowadays?
Any and all advice welcomed, there must be loads of practical and imaginative solutions out there.
Taj very mahal
Does anyone know of a good way to adapt a table so the glass can lift out, saving all the extra space needed in front of it? I'm thinking of something like a track/hinge affair along one or both rails.
Has anyone done this? Is there a company doing this as a service? Would it still be structurally sound?
I'm sure I'm not the only one who could fit more pins in with something like that - I could then use a 7' space instead of needing it to be 9' to allow for glass removal. I think I read somewhere that a table was made like that way back, but I'm not looking for a history lesson, just is it a viable upgrade nowadays?
Any and all advice welcomed, there must be loads of practical and imaginative solutions out there.
Taj very mahal