Gameshow help

[Dalek]

Bally Gameshow
To save my sanity can someone help me with a wiring problem with a couple of Molex connectors on the backbox interconnect board.
Which wires go where on J9 and J6?
A couple of photos if poss would be great! If not, a clear description would be appreciated as I'm a bit of a nooby on this!
It's driving me crazy!!!!
Thanks

 

[Sgt GrizZ]

Check the manual, page 3-16

http://mirror2.ipdb.org/files/985/Bally_1990_Game_Show_Operations_Manual.pdf

 

[Dalek]

Thanks GrizZ, but as I said, I am a complete beginner at this. I have looked at the manual and it seems to bear no relation to what I am actually looking at!
The problem is I have no idea how to read these complicated looking diagrams!
What I need is the Dummy's guide to where the wires go.....
Can someone please help??

 

[RudeDogg1]

I know what you mean I couldn't get my head around them to start with

 

[Dalek]

It doesn't help that my eyesight is not brilliant and I'm colour blind.
All the wires look the same to me.... but I won't give up!! Aren't these problems supposed to be half the fun of owing pins?

 

[RudeDogg1]

The manual isn't coloured ;0) it should tell you the colour of each wire and what pin each one goes to

 

[replicas]

It doesn't help that my eyesight is not brilliant and I'm colour blind.
All the wires look the same to me.... but I won't give up!! Aren't these problems supposed to be half the fun of owing pins?

Sounds like the repair could take a little while. Good luck.

 

[Dalek]

Thank guys!
If someone could photograph J9 for me that would be a real help.

 

[Dalek]

Success!! Thanks to GrizZ and the wiring chart it all working!!
However I have noticed one of the pins that come through the circuit board is damaged. Can you buy these and solder them in myself? If so, any idea where I get them?