Sadly now having to let go of my Funhouse. Has had an awful lot of time spent on it thanks to @JMP and @replicas as it was in quite a state when I got it.
It will be put up on Ebay at the same time sorry due to the £1 listing until 25th
Looking for £1900 obo with donation to site as before
They have completed 98% of it, the only things left are:
Quoted *
"Either battery compartment on CPU is crap or other problem on CPU as no data being saved when new batteries supplied. May just require remote battery compartment, not sure. Sorted. Remote battery fitted
The (-) button behind coin door not working (and can't turn volume down). Loose rogue wire noted but I cannot fathom where it needs to go for button to work (if that's the issue).
Everything else seems to be working fine now. A lot of the mechs needed stripping, rust and gunk removing etc. to get working again. However, I would suggest getting one of these if plan on keeping it:
Marco Specialties Pinball Parts
Drive arm assembly used in solid state Williams/Bally games.
www.marcospecialties.com
Goes on bottom of ramp diverter rod. Existing one has dropped off a few times in game play despite tightening the grub screw best I can. May just need a new grub screw actually (4010-01082-04)."
Not fallen off since I've had it back
Knock and bangs to Cab and Backbox - Touched up in places
Playfield touched up and has Mylar - not the prettiest of Funhouses but seems to play well
As always would prefer for you to come and inspect before paying and taking it away.
Trying to be as honest as possible
Pics to follow
It will be put up on Ebay at the same time sorry due to the £1 listing until 25th
Looking for £1900 obo with donation to site as before
They have completed 98% of it, the only things left are:
Quoted *
"Either battery compartment on CPU is crap or other problem on CPU as no data being saved when new batteries supplied. May just require remote battery compartment, not sure. Sorted. Remote battery fitted
The (-) button behind coin door not working (and can't turn volume down). Loose rogue wire noted but I cannot fathom where it needs to go for button to work (if that's the issue).
Everything else seems to be working fine now. A lot of the mechs needed stripping, rust and gunk removing etc. to get working again. However, I would suggest getting one of these if plan on keeping it:
Marco Specialties Pinball Parts
Drive arm assembly used in solid state Williams/Bally games.
Goes on bottom of ramp diverter rod. Existing one has dropped off a few times in game play despite tightening the grub screw best I can. May just need a new grub screw actually (4010-01082-04)."
Not fallen off since I've had it back
Knock and bangs to Cab and Backbox - Touched up in places
Playfield touched up and has Mylar - not the prettiest of Funhouses but seems to play well
As always would prefer for you to come and inspect before paying and taking it away.
Trying to be as honest as possible
Pics to follow
Last edited: