Hi,
Popped a rev B shaker in my MET and it refuses to kick into life.
Connections:
To front left 2 pin molex carrying power near the coin door (red/red-stripe) (Reads as just over 7v at that molex)
To back 3 pin molex carrying the shaker signal I presume, middle of 3 molex, brown.
To shaker itself
All connectors seated accordingly as I can see.
All fuses on daughter board and sam board OK.
Theres a black 2pin molex labelled shaker ground, but I don't have a connection for that to go on.
Ideas anyone? The machine was predrilled and loomed up for a shaker.
note: it lives, bad connection I think
Popped a rev B shaker in my MET and it refuses to kick into life.
Connections:
To front left 2 pin molex carrying power near the coin door (red/red-stripe) (Reads as just over 7v at that molex)
To back 3 pin molex carrying the shaker signal I presume, middle of 3 molex, brown.
To shaker itself
All connectors seated accordingly as I can see.
All fuses on daughter board and sam board OK.
Theres a black 2pin molex labelled shaker ground, but I don't have a connection for that to go on.
Ideas anyone? The machine was predrilled and loomed up for a shaker.
note: it lives, bad connection I think
Last edited: