Expired Few circuit boards

[paddythegreek]

I need to reduce some of the stuff i've amassed over the years. So to start with

Bally power supply board
AS-2518-22. £35
Wms aux power board
D-12247-566. £30
Wms aux power board
D-12247-563. £30
Wms sys 11b power supply
5765-12317-00. £35
Wms sys 7 power supply
I believe it also fits sys 3/4/6 5765-09466-01 £35 SOLD

All these boards were working when tested in machines.
All plus post at cost.

 

[Jay Walker]

Wms sys 7 power supply
I believe it also fits sys 3/4/6

It does, also system 9 and many system 11 games (those preceding Taxi). The final few, e.g Space Station, used this p/supply, but down-graded to simply produce logic and display power. For these, some fuse holders and connectors were omitted.

 

[Spandangler]

Will it fit Banzai Run Jay?

 

[paddythegreek]

Banzai run is sys 11b so the Wms 11b one will fit. Listed above the sys 7 one

 

[Spandangler]

Hmmm yeah but BR has a different power supply to ww and Taxi. I’ll take a pic of mine for comparison.
If it’s the same I’ll take it.

 

[paddythegreek]

Post a pic of yours as i have others and i'll have a look tomorrow

 

[Spandangler]

Ok mate. Working long shifts at the moment so might not get a chance tomorrow but I’ll do it ASAP

 

[paddythegreek]

Whenever you're ready, they ain't got best before dates on em.

 

[Jay Walker]

Hi, Gaz,

A picture of the boards in Banzai's entry of ipdb shows the simplified 'system 7' power supply, D-8345. The one above is over-specified for Banzai, but it is suitable.

 

[Spandangler]

Thanks Jay. Here is mine

 

[Jay Walker]

That one doesn't even have the wiring attached for general illumination, in the lower right corner (where the breaker relay would be if fully equipped).

 

[Spandangler]

I think the gi goes through the interconnect board.
So having compared the 2 Jay. Do you think paddy’s one will still work ok in mine. My br has a boot up issue in that on switch on, it makes a screech sound and doesn’t boot. Then on second attempt it boots ok.

 

[paddythegreek]

I believe the interconnect board on BR is different to others so you could be right re the GI. Ken

 

[Jay Walker]

Yes, Gaz,

The full-spec one will be alright in your Banzai. If the situation was reversed, i.e. having a stripped-down one and wanting to use it in, for example, a High Speed, you'd be stuck. In your case, there'll just be unused connectors/fuse holders.

 

[Spandangler]

Sweet. I’ll take it then Ken
And as always Jay, thanyou for your help.
I’ll pm you when I get in ken

 

[paddythegreek]

Just thought i give it a bump