Right guys I just put the old working and back in my tz ready for when it goes. I'm sure it's all connected right but the desplay is totally blank no life at all what have I missed?
Pinball info
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
DMD Problem
- Thread starter RudeDogg1
- Start date
- Joined
- Jul 21, 2011
- Messages
- 2,508
Missing voltage , inverted cable , dead dmd.
All good names for a rock band too
OP
OP
Well the dmd was working 100% before
OP
OP
F601 seems to of blown 3/8 amp slow blow do you have any of these @pinballmania ? About the only fuse I don't have typical lol
Did you have a colour dmd installed? IIRC, have you replaced the high power connector correctly for the plasma display.
OP
OP
Yes I did and removed the colour dmd cable and switched back to the original cable everything looks ok. Hopefully the new fuse will sort it
All good names for a rock band too
375mA. I only have 250mA (1/4A) or 500mA (1/2A). I've used 500mA before. If that little chap blows then fear the inevitable.
- Joined
- Jul 21, 2011
- Messages
- 2,508
Yes. I have 3/8a
OP
OP
Email on way
- Joined
- Jul 21, 2011
- Messages
- 2,508
Fuses on way.