Hi
I've been busy on this - got it very nearly finished,
95 tables, all present and correct with PinballX as the front end.
I gave up properly hinging the backbox so it's in 'EM mode' (you can detach it, but with care- its just held in with 4 leg bolts into cross-braces in the main body.)
Few issues with the analog nudging going out of calibration and giving phantom inputs
(I think this may be heat related as I 've not installed the rear fans yet)
But its dialled in other than that, although I'm not a greatly skilled nudger so would need to get someone who actually knows what they're doing to really tell me how good/bad it was.
Still got to sort out the artwork printing (will be TAF as I have good quality scans of this)
Also got to clean the legs and sort them out abit, so I have to kneel on the floor to play it at the moment.
Other than that a bit of cable tidying, install the fans and its done
I've got a load more pics - I'll upload them later on when I get home
Been playing a lot of
CV on it as its one of the most recently done VP10 tables and looks fantastic
That's the problem with making a WIP playable, suddenly all the little finishing off jobs get put to one side for playtesting!
Edit: Also got to sort out some form of cover/rails for the playfield screen - probably just use a Perspex sheet and some right angled aluminium strips held on with double sided tape as it does need to be removable.