The most commonly requested model I've been asked for is a Deadpool to replace the crappy plastic sitting over the left ramp. It's amazing that even the Prem and LE has this plastic.
Well now I've found one a model which perfectly fits that area.
He comes reclining on a bench, but also has string attached so that he could be tied swinging from the original mounts. (I don't envisage it being too hard to cut the bench away so it would appear that he would be swinging).
Here he is pictured with the string removed altogether and he has been attached to the plastic with a dab of hot glue, although double-sided sticky tape would work just as well..
I shall only be placing a single order for these, and hope to have them with me in time to deliver at Pinfest. So if you are interested, post below or PM me - price is £10.
Why not couple it up with Colossus figure I have 3D printed (only 2 remaining) £25 for both.
Well now I've found one a model which perfectly fits that area.
He comes reclining on a bench, but also has string attached so that he could be tied swinging from the original mounts. (I don't envisage it being too hard to cut the bench away so it would appear that he would be swinging).
Here he is pictured with the string removed altogether and he has been attached to the plastic with a dab of hot glue, although double-sided sticky tape would work just as well..
I shall only be placing a single order for these, and hope to have them with me in time to deliver at Pinfest. So if you are interested, post below or PM me - price is £10.
Why not couple it up with Colossus figure I have 3D printed (only 2 remaining) £25 for both.
