Does look really good in black...
yes mate any bolts that tighten into decals leave a while - you can still put them in and not tighten them and comeback to them later on.Cheers Kev. Particularly the advice about not tightening bolts up. Will slacken them off tonight.
I only noticed one side being higher than the other after I’d put both on.
There was only about 15mm overhang on the vertical - which I left at the top, not the bottom so that was schoolboy error on my part. But I left same amount of excess at top on both sides - so should really have centred both by eye to take account of lettering being printed higher up on the decal one side than the other. But then again, like I say was only about 15mm to play with and I think the difference is a lot more than that.
Presumably the same advice about not tightening up leg bolts will also go for back box hinge and playfield lift bracket bolts too so I should wait a week before fixing those back on to let glue properly set?
Of course it will lol!!!!!Cheers mate. Knowing my luck the thing won’t work when I put it back together!
yeah they would look really coolAll you need now is some sideblades
https://www.retrorefurbs.com/shop/star-wars-stern-pinball-sideblades/#iLightbox[]/0
All you need now is some sideblades
https://www.retrorefurbs.com/shop/star-wars-stern-pinball-sideblades/#iLightbox[]/0
I also saw stern use a sticky clothes roller for picking up dust and dirt of the cabinets before they applied the decals (using water).
Nice one @Nedreud. Hadn’t really noticed how the top of the Death Star was chopped off by the side rails on the original.
Wonder how easy it would be to reproduce them with the main image dropped a few inches @PeteB? Would be an improvement over the original artwork I reckon if you could pull it off.
Andy
Cabinet base speaker has a couple of tears in the cone(?) presumably I can just swap it out with any regular 8” speaker e.g. one designed to be fitted in a car as long as the ohms rating is the same?