Okay newbie alert.
So I'm checking all the secondary cable voltages on creech before plugging everything in - in the hopes that I can avoid blowing something up. Checking the Power driver inputs first, meter on VAC, and placing the sensors on each pin either side of the phase.
J115 all okay
J112 all okay
J101 all okay
J102 - The black-yellows (5,6,8,9) are all reading 50VAC (or there abouts). The schematic says this is correct, but the manual is saying it should be 16VAC. I've checked Twilight Zone, Judge Dredd - they all say 16VAC for the black-yellow pins.
So wtf! Surely all the manuals aren't wrong. Am I missing something?
Also as an aside, I've noticed that all the voltages are over by about 5%. I assume this is correct because of UK voltages being 240 not 230, so everything just runs slightly hot?
So I'm checking all the secondary cable voltages on creech before plugging everything in - in the hopes that I can avoid blowing something up. Checking the Power driver inputs first, meter on VAC, and placing the sensors on each pin either side of the phase.
J115 all okay
J112 all okay
J101 all okay
J102 - The black-yellows (5,6,8,9) are all reading 50VAC (or there abouts). The schematic says this is correct, but the manual is saying it should be 16VAC. I've checked Twilight Zone, Judge Dredd - they all say 16VAC for the black-yellow pins.
So wtf! Surely all the manuals aren't wrong. Am I missing something?
Also as an aside, I've noticed that all the voltages are over by about 5%. I assume this is correct because of UK voltages being 240 not 230, so everything just runs slightly hot?
Last edited: