On my bk2k the left flipper has been going very weak and struggling to even move the ball so I thought I'd have a look underneath. When I had a look around the switches a wire dropped down which had obviously broken off a terminal somewhere so thought it must be the cause of the problem (blue wire in photo) Looking at the wiring and how it was bent I presumed it was a daisy chain to the other flipper solenoid so hooked it up to the left most terminal of the right flipper (as looking at the photo) tried the flipper and not much happened so disconnected it.
Then none of the flippers worked at all.
So I opened up the back box and something smelted like it had blown
Checked the fuses and F7 had blown so changed it for a new fuse. Now the left flipper is working soggy like it was before, but neither of the right flippers are working
When I run a switch edge test in the menu the right flipper button doesn't register when I press it
What have I likely blown and where should I start checking?
Then none of the flippers worked at all.
So I opened up the back box and something smelted like it had blown
Checked the fuses and F7 had blown so changed it for a new fuse. Now the left flipper is working soggy like it was before, but neither of the right flippers are working
When I run a switch edge test in the menu the right flipper button doesn't register when I press it
What have I likely blown and where should I start checking?
