Barnfind pinbot shoplog

[Balazs]

I could touch up the paint of the matrix And I put a piece of mylar to the top. I also put some led.

 

[Balazs]

More pictures

 

[Balazs]

Hello
I stripped down the playfield today Im going to touch up the missing painting tomorrow. My plan is to put some playfield protector to the whole playfield.
My thought was to install a 0.5mm or 1mm policarbonate sheet and cut the holes for the screws, bumpers, slinghshots etc. I have not done this before so if somebody can give me advice or what tricks should I use I would apreciate that.
Thanks
Baz

 

[Balazs]

Diy playfield protector

 

[Balazs]

Protector done

 

[TonySchwager]

Protector done

Wow it's really coming along. Looks great

 

[Balazs]

Flipper led upgrade

 

[Spandangler]

Flipper led upgrade

Have you seen the replacement ramps on pinside by freeplay40? Would suit yours down to the ground. Half red half blue transparent ramps. They look right snazzy

 

[Steve64]

Nice work

 

[Balazs]

Legs before, after and illuminated instruction card upgrade

 

[Balazs]

Yikes. Those aint coming back!!

Great stencil work by the way

The legs have already came back to the life.

 

[Balazs]

 

[AlanJ]

nice

 

[Balazs]

Im forgot to upload some pictures

 

[cmrl9]

Coin door in progress

Wow

 

[cmrl9]

I tried to peel off the bubbled mylar.
It turn out pretty good but still need some touch up.
I used hair drier and flour +90% alcohol for the old glue.

That is amazing work

 

[cmrl9]

Legs before, after and illuminated instruction card upgrade

Are they the same legs?

 

[cmrl9]

That's amazing what can be done, bringing a pin back from the dead is always great to see

 

[Balazs]

Are they the same legs?

Yes those are the same legs with new levellers

 

[Balazs]

Are they the same legs

 

[cmrl9]

Yes those are the same legs with new levellers

wow very impressive.

 

[Dotteddown]

The artwork looks great
Those colours