bally vector no 46v from pin 1 of J2

[stevebm1]

during a game,my bally vectors right flippers have stopped working,so I cleaned up the flipper button leaf switch,but still no joy,so I got the multimeter out and checked for voltages to the button,and found that there is no 46v from pin 1 of j2 on the solenoid driver board,pin2 has 46v and the left flippers work fine,this is the first bally iv'e had for a while,so any ideas where to look?,ive checked and reseated all the connectors,the game starts and plays fine,but no right flippers

 

[backbox]

Hi Steve, the Bally setup is to permanently feed 43V to one end of the flipper solenoids and ground the other ends via the flipper switches to activate.
The 43V you're measuring at A3 J2-2 is not a 'hard' 43V, i.e. it has come via the flipper solenoid, EOS switch and flipper enable relay.

So ...
check you have 43V to either/both of the RH flippers.
if yes, check for 43V at solenoid driver (A3) J1-9
A3 J1-9 passes through the flipper enable relay on the solenoid driver board to A3 J2-1 ... but you're not getting it here!!

good luck
Rob

 

[stevebm1]

thanks for the reply,I will have a check tommorow,can't do it tonight as I have to play good husband and go out with the wife

 

[stevebm1]

well I checked the voltages after reflowing the connectors on the driver board,and it's all working again now fingers crossed