ok guys I have been restoring my SI for a few months she's mostly up and running....
iv fitted all new transformer and rec board
and all new altek boards yes all of them lol
but I still cant seem to get the flippers to work or even the relay on the solenoid board to do anything
what I have figured out so far:-
I have continuity from the flipper buttons to the lower connector on the board (blue and red wires)
and after disordering the flipper coil wires I have continuity form the upper plug (green and orange wires)
and if I connect the plugs and check continuity from the solenoid end of the green and orange wires to ground and push the little red button on the bottom of the relay in I get a good beep too!
my question is how is the relay on the solenoid driver board actuated?
I thought it was just from the flipper button inputs ?
and powered from the solenoid driver board?
thankyou for any help
this is one of the last few things I need before its running again!
cheers Oliver
iv fitted all new transformer and rec board
and all new altek boards yes all of them lol
but I still cant seem to get the flippers to work or even the relay on the solenoid board to do anything
what I have figured out so far:-
I have continuity from the flipper buttons to the lower connector on the board (blue and red wires)
and after disordering the flipper coil wires I have continuity form the upper plug (green and orange wires)
and if I connect the plugs and check continuity from the solenoid end of the green and orange wires to ground and push the little red button on the bottom of the relay in I get a good beep too!
my question is how is the relay on the solenoid driver board actuated?
I thought it was just from the flipper button inputs ?
and powered from the solenoid driver board?
thankyou for any help
this is one of the last few things I need before its running again!
cheers Oliver