3 pin molex connectors as used on Sterns

[kevlar]

Does anyone know what size pins are used in the 3 pin molex connectors often used to connect mods to the spare accessory connector in stern machines? 0.093" or 0.156"?

Also where is the best place to get them? ( male/female connector housings & pins )

Cheers

Kev

 

[astyy]

I've bought housing and pins recently from RS Online.

 

[kevlar]

I've bought housing and pins recently from RS Online.

Thanks, do you know what size they are?

 

[astyy]

I don't know about Sterns but common all over my VECTOR is .062" pins, these ones;
https://uk.rs-online.com/web/p/pcb-connector-contacts/2363044/

 

[kevlar]

Thanks astyy, I specifically need to know the size to fit the stern connector though.

 

[astyy]

Understood. If have either side of the connector you require to measure I have examples of both Molex Standard 0.062" and 0.093" 3-pin connectors here. The spec's for both are on the Molex website
http://www.molex.com/molex/products/group?key=wire_to_wire_connectors&channel=products

Saying that a Stern owner can probably verify which it is

 

[kevlar]

Understood. If have either side of the connector you require to measure I have examples of both Molex Standard 0.062" and 0.093" 3-pin connectors here. The spec's for both are on the Molex website
http://www.molex.com/molex/products/group?key=wire_to_wire_connectors&channel=products

Saying that a Stern owner can probably verify which it is

Thanks, using the website and rule I have worked out and ordered what I need. They were 0.093" btw.

 

[astyy]

Cool. I haven't needed to make up that size, the 0.062" is common for wire-to-wire in my Ballys and the chunkier MLX series to the power board. That 0.093" takes wire up to 14 AWG - do you have the crimp tool for that?

 

[kevlar]

Yes I believe my crimper does that size, if not will borrow one from work.